AQUACOAT 5020 MANUAL

 

Large cabinet for the electrostatic processing of water-based lacquers and separating agent with manual guns. Completely insulated construction with internal charging of the materials for manual spraying applications, AirSpray and AirCoat. Basic spray sets including cabinet & control unit, pump set, and guns available, can also be customized.

Features and Benefits

  • Compliance with VOC regulations due to the avoidance of solvent-based materials.
  • Maximum level of safety thanks to mechanical locking during application and restriction of the discharge energy to 350 mJ.
  • Optimal adaptation of the system to customer requirements due to various components and options.
  • Reproducible coating result by selecting from up to three receipts on the gun and locking of the process parameters.
  • Improvement in material efficiency due to the Spray-O-Round effect.
  • Reduction in dirt and required cleaning work thanks to minimal overspray.

Application

  • Wood finishing 
  • Ideally suited for coating geometrically complex components and surfaces, such as window units and chairs.
  • Efficient operating speed for pressure ranges up to 250 bar.
  • Improved edge coverage due to less thinning of the coating material at the edges.
  • Plastic finishing
  • Drum painting 
  • Metal furniture and fixture manufacturing 
  • General metal
  • Corrosion protection
  • Metal protection and finishing
  • Suitable for coating geometrically complex components, both for low and high surface powers.
  • Improved edge coverage due to less thinning of the coating material at the edges.
  • Excellent coating of different geometries due to formula selection on the gun.
  • Efficient operating speed for pressure ranges up to 250 bar.
  • Aerospace industry
  • Automotive components
  • Electrostatic processing of waterbased release agents for the general and automotive supply industry.
  • Ultra-fine atomization & homogeneous wetting with the lowest coating thicknesses.
  • Facilitation of workpiece removal thanks to even wetting of geometrically complex shapes.
  • Improved handling & fatigue-free work during manual coating with DN3 hoses.
  • Motorcyle parts

Typical Fluid Handled

  • Primers, protective coatings, waterborne materials and two-part urethane
  • Wash coats, glazes, top coat lacquers and catalyzed varnishes 
  • Epoxies, urethanes, air dry enamels and clear coat enamels
  • High solid materials
  • UV paints
  • Primer and top coat
Technical Data

CategoryData
OUTPUT VOLTAGE 70,0 kV
OUTPUT CURRENT 100 µA
TOTAL CAPACITY 60 l, 15,85 gal(US)
LENGTH 560,0 mm, 22.0 in.
WIDTH 1000 mm, 39.4 in.
HEIGHT 1470 mm, 57.9 in.
//Counter