: Plural Component Sprayer

PF60 24:1 Plural Component Sprayer

PF60 24:1 Compact 6" Air Motor for spraying PU foam application

COSMOSTAR PF60 24:1 with mixing ratio 1:1 are designed to overcome the toughest job site environment. Equipped with two positive displacements can provide the most reliable mixing ratio and Compact 6" can always achieve your expectation about fluid atomization.

Features

Two and three-lower designs achieve a wide variety of mix ratios
Two-lower design for a consistent 1:1 mix ratio
Reduces material and solvent waste
Provides accurately mixed and proportioned material on demand

Application

Plural component materials
Foam insulation

Typical Fluids Handled

Epoxies
Polyurethanes
High solids polyurethane coatings

Technical Data

Category	Data
Air Motor Diameter	6 inches (Compact)
Mix Ratio	1:1
Pressure Ratio (Fluid to Air)	24:1
Maximum Fluid Working Pressure	200 bar (2880 PSI)
Maximum Air Input Pressure	8.3 bar (120 PSI)
Maximum Volume Flow Rate	4.4 LPM (1.16 GPM)
Volume Per Cycle	74 cc
Maximum Recommended Pump Speed	60 CPM
Air Inlet Size	3/8 pt(f)
Fluid Inlet Size	3/4 pt(f)
Fluid Outlet Size	1/4 pt(f)
Maximum Operating Temperatur	180F (82C)

Plural Component Sprayer

Plural-component equipment is used to spray very high and 100% solids coatings with pot lives that are very short—from as little as 30 seconds up to a few minutes.

COSMOSTAR Plural Component Sprayer is designed for spraying high viscosity fluid, high solid content material coating. The gravity feed, flush pump and fluid heater can be implemented to face the hardest environment and any coating applications.

Getting the “right and accurate” equipment is the most important consideration in coating PU foam and polyurea, or any 2K material. COSMOSTAR SD/PF series plural component can always be your solution by providing high power output with precision mixing ratio.